3. Install the certificate by following the Certificate Import Wizard instructions.
• For details about how to install the certificate and about where to store the certificate when accessing
the machine using IPP, see Web Image Monitor Help.
• If a certificate issued by a certificate authority is installed in the machine, confirm the certificate store
location with the certificate authority.
Setting the SSL / TLS Encryption Mode
By specifying the SSL/TLS encrypted communication mode, you can change the security level.
Encrypted Communication Mode
Using the encrypted communication mode, you can specify encrypted communication.
Ciphertext Only
Allows encrypted communication only.
If encryption is not possible, the machine does
not communicate.
Ciphertext Priority
Performs encrypted communication if encryption
is possible.
If encryption is not possible, the machine
communicates without it.
Ciphertext/Cleartext
Communicates with or without encryption,
according to the setting.
Setting the SSL / TLS encryption mode
This can be specified by the administrator.
After installing the device certificate, specify the SSL/TLS encrypted communication mode. By making this
setting, you can change the security level. Specify the SSL/TLS encrypted communication mode using Web
Image Monitor.
1. Log on to Web Image Monitor in the administrator mode.
2. Click [Configuration].
3. Click [SSL/TLS] in the "Security" area.
4. Select the encryption communication mode in the "Permit SSL/TLS Communication" list, and
then click [OK].
Select [Ciphertext Only], [Ciphertext Priority], or [Ciphertext/Cleartext] as the encrypted
communication mode.
Protection Using Encryption
343
To Next Page
Loading...
Need help?
General
