msh> set diprint {up | down}
msh> set diprint6 {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set ipp {up | down}
msh> set ipp6 {up | down}
msh> set http {up | down}
msh> set http6 {up | down}
msh> set bonjour {up | down}
msh> set bonjour6 {up | down}
msh> set ssl {up | down}
msh> set ssl6 {up | down}
• If Secured Sockets Layer (SSL, an encryption protocol) function is not available for the
printer, you cannot use the function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set rfu6 {up | down}
msh> set ssh {up | down}
msh> set ssdp {up | down}
msh> set nbt {up | down}
msh> set sftp {up | down}
msh> set sftp6 {up | down}
msh> set wsdev {up | down}
msh> set wsdev6 {up | down}
• If "wsdev" and "wsdev6" are enabled simultaneously, both appear as "up" on the protocol
information display, but both use IPv4 for WS-Device and WS-Printer.
msh> set wsprn {up | down}
msh> set ipds {up | down}
msh> set rhpp {up | down}
msh> set rhpp6 {up | down}
show
Use the "show" command to display network interface board configuration settings.
5. Monitoring and Configuring the Printer
242
To Next Page
Loading...
Need help?
General
