7. Print a configuration page to confirm the settings made.
• "Printing the Test Page", Quick Installation Guide.
Setting the Ethernet Speed
You can set the speed that the printer will use for Ethernet communications. In most cases, this should be
left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the
optimum speed when they are connected.
Router/HUB
Printer
10Mbps Half
D.
10Mbps Full
D.
100Mbps Half
D.
100Mbps Full
D.
Auto Select
10 Mbps half
duplex
- - -
10 Mbps full
duplex
- - - -
100 Mbps half
duplex
- - -
100 Mbps full
duplex
- - - -
auto-
negotiation
(auto
selection)
- -
• Connection cannot be established if the selected Ethernet speed does not match your network's
transmission speed.
• The auto-negotiation mechanism allows two interfaces to automatically determine an optimum
Ethernet speed as soon as they are connected. We recommend you select [Auto Select].
Ethernet Configuration
67
To Next Page
Loading...
Need help?
General
