You can specify the method of registering an A record when the dynamic DNS function is enabled
and DHCP is used.
• {own}
To register an A record using the printer as the DNS client.
The DNS server address and the domain name already designated are used for the registration.
Record updating interval settings
msh> dns interval "time"
• You can specify the interval after which records are updated when using the dynamic DNS
function.
• The updating interval is specified hourly. It can be entered between 1 and 255 hours.
• The default is 24 hours.
resolv.conf display
msh> dns resolv
Specifying the protocol when asking names during dual stacking
msh> dns resolv protocol {ipv4|ipv6}
• Appears during dual stacking only.
domainname
Use the "domainname" command to display or configure the domain name settings.
You can configure the Ethernet interface or wireless LAN interface.
View settings
The following command displays the current domain name:
msh> domainname
Interface domain configuration
msh> domainname "interface_name"
Setting the domain name
msh> domainname "interface_name" name "domain name"
• A domain name can be entered using up to 63 alphanumeric characters.
• The Ethernet interface and wireless LAN interface will have the same domain name.
• wlan can be specified only when the wireless LAN interface unit is installed.
Interface Interface set
ether Ethernet interface
Remote Maintenance by telnet
229
To Next Page
Loading...
Need help?
General
