6
Handling the Main Machine
R WARNING:
R CAUTION:
Important
❒ Rating voltage of the connector for options: Max. DC 24 V.
❒ Voltage must not fluctuate more than 10%.
• Turn off the power and disconnect the power plug (by pulling the plug,
not the cable) if any of the following occurs:
• You spill something into the machine.
• You suspect that your machine needs service or repair.
• The external housing of your machine has been damaged.
• For environmental reasons, do not dispose of the machine or expended
supply waste at household waste collection points. Disposal can take place
at an authorized dealer.
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
• When moving the printer after use, do not take out any of the toners, photo
conductor units, nor the waste toner bottle to prevent toner spill inside the
machine.
• When moving the machine, hold the inset grips at both sides, and then lift
the printer slowly. Lifting it carelessly or dropping it may cause an injury.
To Next Page
Loading...
Need help?
General
