5. Press the [ ] or [ ] key to set the network protocol, and then press the [ Enter] key.
6. Press the [ ] or [ ] key to display [Active] or [Not Active], and then press the [ Enter] key.
Set other protocols you need to set in the same way.
• Select [Not Active] for unused protocols.
• Enable IPv4 to use the Pure IPv4 environment of NetWare 5/5.1, NetWare 6/6.5.
7. Press the [Escape] key until the screen returns to the [Network Setup] menu.
8. If you use IPv4, assign the IPv4 address to the printer. Press the [ ] or [ ] key to display
[IPv4 Settings], and then press the [ Enter] key.
To get the IP address for the printer, contact your network administrator.
9. To specify the IP Address, Press the [ ] or [ ] key to display [IPv4 Address], and then press
the [ Enter] key.
If you use IPv4, also assign subnet mask and gateway address.
10. Press the [ ] or [ ] key to enter the address, and then press the [ Enter] key.
Press the [ ] or [ ] key to enter the left most entry field of the address. After entering the left field,
press the [ Enter] key, and then you can enter the next field. After completing to enter in the all fields,
press the [ Enter] key.
Do not set "11.22.33.44" as the IP address.
Ethernet Configuration
63
To Next Page
Loading...
Need help?
General
