Key Repeat Rate
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a
default of 15 times per second.
To change this setting:
1. Touch to select "Key Repeat Initial Delay" from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
Touch "Back" to cancel and return to the Configuration Menu.
Wiper Message
To change this setting:
1. Touch to select "Wiper Message" from the Configuration Menu.
2. Touch or to change the value. The values are On (default) and Off.
3. Touch "Submit" to save the change.
Touch "Back" to cancel and return to the Configuration Menu.
Clear Custom Status
No values exist for this operation. Pressing initiates this operation.
Touch to select "Clear Custom Status" from the Configuration Menu.
• Executing this operation erases any strings that have been defined by the user for the default or
alternate custom messages.
USB Speed
The USB Speed setting is used to set the throughput of the USB port on the machine. The settings are
Auto, whichis the default, and Full. Full forces the USB port to tun at full speed.
USB PnP
This setting is used to improve the machine’s compatibility with the host PC.
Configuration Menu (CONFIG MENU)
159
To Next Page
Loading...
