4. Lift the flatbed cover and unsnap the three tabs (A) securing the ADF rear cover to the ADF.
5. Rear ADF cover.
6. Disconnect the ADF cable (B) and two sensor connections (C) on the relay card above the ADF
relay cable.
7. Disconnect the ADF cable from connector J17 on the controller board.
8. Disconnect the ADF cable ground from the controller cage.
9.
Take out the ADF cable.
Left Scanner Cover Removal
1. Lift the ADF to the up position.
4. Replacement and Adjustment
124
To Next Page
Loading...
