This setting enables you to restore all of the machine’s settings to the base machine settings, the network
settings, or to remove all LES applications.
To restore the Factory Default settings:
1. Touch "Factory Defaults" from the Configuration Menu.
2. Touch "Restore Base" to restore all non-critical base machine NVRAM settings.
3.
Touch "Restore Network" to restore all network NVRAM settings.
4. Touch "Restore LES" to remove all LES applications.
When you select either value, the LCD displays "Restoring Factory Defaults" and then "Resetting the
Device". The device immediately performs a POR and restores the appropriate settings to their factory
default values.
The following settings are not changed:
• Display Language (general settings)
• Network/Ports Menu
• Standard USB, USB (x) Menus (if an ENA is installed)
Energy Conserve
This menu controls what values appear on the Power Saver menu. If "Off" is selected in the Energy
Conserve menu, then "Disabled" appears in the Power Saver menu, and Power Saver can be turned off.
If "On" is set in the Energy Conserve menu, the Power Saver feature cannot be disabled.
To change this setting:
1. Touch "Energy Conserve" from the Configuration Menu. [setting's current value] appears on
the touch-screen.
2. Touch or to scroll through the setting's possible values.
3. Touch "Back" to cancel and return to the Configuration Menu.
4. Touch "Submit" to save the change.
Min Copy Memory
Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value,
that is, at least 200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1. Touch "Min Copy Memory" from the Configuration Menu. [setting's current value] appears
on the touch-screen.
2. Touch to decrease the setting's value; touch to increase the setting's value.
3. Touch "Back" to cancel and return to the Configuration Menu.
5. System Maintenance
148
To Next Page
Loading...
