4. To initiate the reset operation, touch "Yes".
Reset Photoconductor Maintenance Counter (Reset PC Cnt)
This setting resets the photoconductor kit page counter and clears any warnings or photoconductor
exhausted messages. This operation should be performed only after a new photoconductor unit has
been installed.
USB Scan to Local
USB Scan to Local enumerates a USB simple device or USB composite device. In the off position the
simple USB device is enumerated: in the on position, the composite USB device is enumerated.
To change this setting:
1. Touch "USB Scan to Local" from the Configuration Menu. [setting's current value] appears on
the touch-screen.
2. Touch or to scroll through the setting's possible values.
3. Touch "Back" to cancel and return to the Configuration Menu.
4. Touch "Submit" to save the change.
Print Quality Pages
This setting is a limited version of the "Print Quality Pages" setting that appears in the "Diagnostics" menu.
This setting reports the values of a broad range of machine settings and tests the machine’s ability to
generate acceptable printed output.
To print the Print Quality Pages:
1. Touch "Print Quality Pages" from the Configuration Menu. "Printing Quality Test Pages..." appears
on the LCD.
Touch "Back" to return to the Configuration Menu.
The Reports menu contains two selections: Menu Settings Page and Event Log.
Menu settings page
To print the Menu Settings page, press . Press to return to the Configuration menu.
Configuration Menu (CONFIG MENU)
145
To Next Page
Loading...
