Installation note: Use a flathead screw driver to press in on the door mount (B) while pulling on the
front access door to connect the cover to the hinge (C).
LVPS/HVPS Removal
1. Rear cover ( p.102 "Rear Door and Lower Rear Cover Removal")
2. Left side cover ( p.66 "Left Side Cover Removal")
3. Place the printer on its top with the rear facing you.
• Be careful to not mar the finish of the printer.
4. Remove the two screws (A) from the right rear foot assembly.
4. Replacement and Adjustment
70
To Next Page
Loading...
