Ricoh LI-MF1 M126 - Num Pad Job Assist; Format Fax Storage; Fax Storage Location

4. Touch "Submit" to save the change.
Num Pad Job Assist
This setting determines if a user can configure and initiate a job using the panels hard buttons.
To change this setting:
1. Touch "Num Pad Job Assist" from the Configuration Menu. [setting's current value] appears
on the touch-screen.
2. Touch or . The settings are On or Off.
3. Touch "Submit" to save the change.
Format Fax Storage
This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1. Touch "Format Fax Storage" from the Configuration Menu.
• If an advanced password has been established, you must enter this password in order to
change the setting. If no advanced password exists, you can establish one by using the
keyboard that appears on the LCD.
2. Touch "Submit" to save the change.
3. Touch "Back" to cancel and return to the Configuration Menu.
"Formatting Fax Flash DO NOT POWER OFF" appears on the LCD while the format operation is active.
Fax Storage Location
To change this setting:
1. Touch "Fax Storage Location" from the Configuration Menu. [setting's current value] appears
on the touch-screen.
2. Touch or . The settings are Disk and NAND.
3. Touch "Submit" to save the change.
Configuration Menu (CONFIG MENU)
149
5