2. Touch to select Quick Test. The message "Quick Test Printing…" appears on the display. Once
the Quick Test Page completes printing, the Registration screen displays again.
3. Touch "Back" to return to the Diagnostics Menu.
Print Tests
This setting tests the machine’s ability to generate printed output from each of its installed input sources
and to test the machine’s current print quality.
Input sources
The purpose of the diagnostic Print Tests is to verify that the machine can print on media from each of the
installed input options. The contents of the Print Test Page varies depending on the media installed in the
selected input source.
Check each Test Page from each source to assist in print quality and paper feed problems.
To run the Print Test Page:
1. Select PRINT TESTS from the Diagnostics menu.
2. Select the media source to test:
Tray 1
Tray 2 (if installed)
MP Feeder
Envelope Feeder/MP Feeder
3.
Select "Single" or "Continuous".
• If "Single" is selected, a single page is printed.
• If "Continuous" is selected, printing continues until "Stop" is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
• The Print Test Page always prints on one side of the paper, regardless of the duplex setting or
the presence of a duplex option.
Touch "Back" to return to PRINT TESTS.
Print quality pages (Prt Quality Pgs)
The purpose of this diagnostic function is to allow printing of the print quality test pages with the toner
cartridge lockout function disabled. The print quality pages consist of four pages. Page one contains a
mixture of graphics and text. Page two is gray with two one-inch black squares located on the bottom
5. System Maintenance
164
To Next Page
Loading...
