2. Remove the three screws (A) from the right rear frame assembly.
3. Carefully lift the right rear frame assembly off the print engine frame.
Tub Assembly Removal
1. Flatbed assembly ( p.111 "Flatbed Removal")
2. Disconnect the remaining cables from the controller board.
3. Thread the cables through the tub assembly and top cover.
4.
Controller board cage (
p.50 "Controller Board Cage")
5. Operator panel keyboard ( p.90 "Operator Panel Keypad Removal")
6. Operator panel display ( p.91 "Operator Panel Display Removal")
7. Left rear frame assembly ( p.96 "Left Rear Frame Assembly Removal")
4. Replacement and Adjustment
98
To Next Page
Loading...
