3. Remove the three screws (A) from the shield.
4. Remove the four screws (B) from the duplex.
5. Lift the duplex slightly, push to the left, and tilt to clear the right side of the printer.
6. Take out the duplex.
Duplex/Main Motor Gear Drive Interface Removal
1. LVPS/HVPS ( p.70 "LVPS/HVPS Removal")
2. Duplex ( p.54 "Duplex Removal")
3. Main motor gear drive ( p.72 "Main Motor Gear Drive Removal")
Removal Procedures
55
To Next Page
Loading...
