• Empty—Input tray empty sensor
• Low—Input tray paper low sensor
• PassThru—Input tray pass thru sensor
4.
Once this message displays, the technician can manually actuate each sensor. The tray empty
sensor can be actuated by hand, but a sheet of paper can be used to cover the pass thru sensor.
When the sensor is closed, "Closed" displays; when the sensor is open, "Open" displays.
5. Press "Stop"
to exit the test.
Output Bin Tests
Feed tests (output bins)
Use these tests to verify that media can be fed to the standard output bin. No information is printed on
the media fed to the output bin, because the printhead is not engaged during this test. These tests can
use any media size or envelope supported by the machine.
To run the Feed Tests for the output bins:
1. Touch to select "Feed Tests" from the OUTPUT BIN TESTS.
2. Touch to select the output bin you want the paper to exit into.
3. Touch to select either Single or Continuous.
• "Single"—feeds one sheet of media from the selected source.
• "Continuous"—media continues feeding from the selected source until "Stop" is pressed.
Touch "Back" to return to OUTPUT BIN TESTS.
Sensor test (standard output bin)
This test is used to verify if the standard bin sensor is working correctly.
To run the Sensor Test for the standard bin:
1. Touch to select "Sensor Test" from OUTPUT BIN TESTS.
2. Touch to select "Standard Bin" from Sensor Tests.
3. Manually actuate the bin sensor by moving the flag in and out of the sensor, and the display
changes. The following screen is displayed:
"Bin Empty: empty" or "Bin Empty: full".
4. Press "Stop" to exit the test.
5. System Maintenance
172
To Next Page
Loading...
