ADF Edge Erase
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy jobs
have a minimum of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever
is larger.
To adjust the ADF edge erase setting, perform the following steps:
1. Touch "ADF Edge Erase" from the Configuration Menu. [setting's current value] appears on
the touch-screen.
2. Touch to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
4. Touch "Back" to cancel and return to the Configuration Menu.
FB Edge Erase
This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will
use the setting or two millimeters, whichever is larger.
To adjust the flatbed edge erase setting, perform the following steps:
1. Touch "FB Edge Erase" from the Configuration Menu. [setting's current value] appears on the
touch-screen.
2. Touch to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
4. Touch "Back" to cancel and return to the Configuration Menu.
Scanner Manual Registration
This item is used to manually register the flatbed and ADF on the machine’s scanner unit. Registration
should be performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register a Duplex ADF, perform the following steps:
1. In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2. Touch Scanner Manual Registration.
3.
Touch the Print Quick Test Page menu item.
4. To view and adjust the duplex ADF front side registration, place the quick test page face up into the
ADF.
5. Touch Copy Quick Test.
6. After the quick test page copies, touch ADF Front.
7. Use the
or to increase or decrease the settings value for horizontal adjust and top margin.
5. System Maintenance
150
To Next Page
Loading...
