Input Tray Tests
Feed tests (input tray)
This test lets the technician observe the paper path as media is feeding through the machine. A blank
sheet of paper feeds through the machine as the laser turns off during this test. The only way to observe
the paper path is to open the lower front door that is used to access the envelope or multipurpose
feeder. The paper is placed in the output bin.
To run the Input Tray Feed Tests:
1. Touch to select "Feed Tests" from INPUT TRAY TESTS.
2. Touch to select the input source from the sources displayed on the Feed Tests menu. All
installed sources are listed.
3. Touch to select either Single or Continuous.
• "Single"—feeds one sheet of media from the selected source.
• "Continuous"—media continues feeding from the selected source until "Stop" is pressed.
Sensor test (input tray)
This test is used to determine if the input tray sensors are working correctly. To run the Input Tray Sensor
Test:
1. Touch to select the "Sensor Test" from INPUT TRAY TESTS.
2. Touch to select the input source from the sources displayed on the Sensor Test menu. All
installed sources are listed.
3. Select the sensor to test. Various sources have different combinations of sensors. See the table
below:
Tray sensor support by source
Source
Empty
(Input tray empty
sensor)
Low
(Input tray paper low
sensor)
PassThru
(Input tray pass thru
sensor)
Tray 1
Tray 2
Multipurpose tray
Envelope feeder
[sensor selected]=Open displays.
Diagnostics Menu
171
To Next Page
Loading...
