• If the cable is not properly installed in its retainers, then the loose cable will obstruct the paper
path.
• Check to make sure the duplex paper jam door is in its proper position. The cover must be
closed (in the ‘down’ position), and the ends of the shaft must be in the holders. If it is not, then
the paper tray will become lodged and the printer will need to be replaced.
Multipurpose Feeder Removal
1. Open the front access door.
2. Remove the four screws (A) from the upper front guide.
3. Upper front guide.
4. Replacement and Adjustment
86
To Next Page
Loading...
