Ricoh LI-MF1 M126 - Paper Input and Duplex Sensor Assembly Removal

8. Right rear frame assembly ( p.97 "Right Rear Frame Assembly Removal")
9. USB cable mount bracket ( p.94 "USB Cable Mount Bracket Removal")
10. Operator panel support ( p.95 "Operator Panel Support Removal")
11. Operator panel display rotation support ( p.95 "Display Rotation Support Removal")
12. Remove the top and side screws securing the left flatbed support.
13. Left flatbed support.
14.
Remove the top and side screws securing the right flatbed support.
15. Right flatbed support.
16. Lift the tub assembly off the machine.
• After removing the tub assembly, remove the output bin LED and LED cover ( p.122
"Output Bin LED and Lens Removal"). These will be used on the new tub assembly.
Paper Input and Duplex Sensor Assembly Removal
1. Right side cover ( p.104 "Right Side Cover Removal")
2. Duplex ( p.54 "Duplex Removal")
3. Remove the two screws (A) from the sensors.
Removal Procedures
99
4