Ricoh M065 - Page 568

System Service Mode
M065/M066 8-158 SM Appendix
2822
[SP 2: SW Timing: L-Edge] DFU
Adjusts the bias/ voltage switch timing of the paper transfer roller/ discharge
plate at the paper leading edge between the erase margin area and the image
area.
Middle: 182 mm/sec, Low: 85 mm/sec
001 Paper Transfer: Middle: 1st *ENG
[0 to 50 / 0 / 2 mm/step]
002 Paper Transfer: Middle: 2nd *ENG
003 Paper Transfer: Low: 1st *ENG
004 Paper Transfer: Low: 2nd *ENG
005 Separation DC: Middle: 1st *ENG
006 Separation DC: Middle: 2nd *ENG
007 Separation DC: Low: 1st *ENG
008 Separation DC: Low: 2nd *ENG
2823
[SP 2: T-Edge Correct] DFU
Special 2 Paper: Trailing Edge Correction
Adjusts the correction to the paper transfer roller current for the paper trailing
edge in each mode. SP2803 and SP2807 are multiplied by these SP values.
Middle: 182 mm/sec, Low: 85 mm/sec
 The paper trailing edge area can be adjusted with SP2824.
001 Paper Transfer: Middle: 1st *ENG
[0 to 995 / 100 / 5%/step]
002 Paper Transfer: Middle: 2nd *ENG
003 Paper Transfer: Low: 1st *ENG
004 Paper Transfer: Low: 2nd *ENG
005 Separation DC: Middle: 1st *ENG