System Service Mode
M065/M066 8-214 SM Appendix
3514
[Environmental Displ: Job End]
Displays the environmental conditions at the last job.
These are used for process control execution timing.
001 Temperature *ENG
[-1280 to 1270 / 0 / 0.1°C/step]
002 Relative Humidity *ENG
[0 to 1000 / - / 0.1%RH/step]
003 Absolute Humidity *ENG
[0 to 1000 / - / 0.1 g/cm
3
/step]
3515
[Execution Interval: Display]
Displays the current interval for process control execution.
When the machine calculates the timing for process control, it uses a number
of conditions. These are the results after considering all the conditions.
001 Job End: Process Control: BW *ENG
[0 to 2000 / 500 / 1 page/step]
002 Job End: Process Control: FC *ENG
[0 to 2000 / 200 / 1 page/step]
003 Interrupt: Process Control: BW *ENG
[0 to 2000 / 500 / 1 page/step]
004 Interrupt: Process Control: FC *ENG
[0 to 2000 / 200 / 1 page/step]
3516
[Refresh Mode] DFU
While making prints with low coverage, the developer is agitated with less
toner consumption and the toner carrier attraction tends to increase. This may
cause low image density or poor transfer (white dots). To prevent this, the
coagulated toner or overcharged toner has to be consumed by performing the
refresh mode.
001 Dev. Motor Rotation: Display: Bk *ENG
[0 to 1000 / 0 / 0.1 m/step]
002 Dev. Motor Rotation: Display: C *ENG
003 Dev. Motor Rotation: Display: M *ENG
004 Dev. Motor Rotation: Display: Y *ENG
To Next Page
Loading...
