USB Device Server Option Type M19 (D3BC-28, 29)
D255/D256/M281/M282 2-112 SM
No. Item Description
1 Switch Use to reset to the factory settings.
2 Ethernet port Use to connect the Ethernet cable.
3 USB port
Use to connect this option to the main machine.
Do not use this port with other options.
2.13.2 INSTALLATION PROCEDURE
When you install this option to the main machine for the first time, the interface board
must be connected directly to your PC to set up the IP address and other network
settings.
Turn OFF the main power, and unplug the machine power cord before starting the
following procedure.
1. Loosen the two screws and remove the slot cover [A] from the rear side of the
machine.
2. Fully insert the interface board [A].
To Next Page
Loading...
