Ricoh M281 Series - Installing the fax connection unit

Fax Connection Unit Type M24 (D3CP-05, 06, 07)
D255/D256 FAX OPTION 2 SM
2. Install the Fax Connection Unit in the client machine (fax unit is not installed).
3. Register the client machine in the remote machine.
 Do not register the remote machine before the client machine is registered on the
remote machine. Otherwise, the remote machine can not be registered.
4. Register the remote machine in the client machine.
Installing the fax connection unit
 Before starting this procedure, connect the network cable to the target machine(s), and
then configure the network settings.
 When installing more than one SD card, perform the merge operation. For details about
how to merge, refer to "SD Card Appli Move" in "Main Chapters" of the field service
manual.
1. Turn OFF the main power.
2. Open the rear upper cover [A].
3. Insert a flathead screwdriver into [A] to release a hook of the controller cover [B].
4. Release the hook by opening the right side of the cover, and then remove the cover [A]
by rotating it in the direction of the blue arrow.