Ricoh M281 Series - INPUT AND OUTPUT CHECK; INPUT CHECK TABLE (SP5-803); OUTPUT CHECK TABLE (SP5-804)

Input and Output Check
SM Appendix 3-165 D255/D256/M281/M282
SP Mode Tables
3.14 INPUT AND OUTPUT CHECK
3.14.1 INPUT CHECK TABLE (SP5-803)
When entering the Input Check mode, 8 digits display the result for a section. Each digit
corresponds to a different device as shown in the table.
Bit No. 7 6 5 4 3 2 1 0
Result 0 or 1 0 or 1 0 or 1 0 or 1 0 or 1 0 or 1 0 or 1 0 or 1
SP Description
Reading
0 1
5-803-001 Exit Full Sensor Paper detected Paper not detected
5-803-016 Key Card Set Set Not set
5-803-017 Key Counter Set Set Not set
5-803-018 IPU Version - -
3.14.2 OUTPUT CHECK TABLE (SP5-804)
Activates the electrical components for functional check.
It is not possible to activate more than one component at the same time.
SP Display
5-804-001 CTLFAN Motor
5-804-101 FAN:LSU/DLP/CENTER/REAR
5-804-102 FAN:LVU
5-804-103 Toner Motor
5-804-202 Scanner Lamp