USB Device Server Option Type M19 (D3BC-28, 29)
D255/D256/M281/M282 2-114 SM
6. Only when installing this option in NA, fix each ferrite core with the cable tie [A].
7. Insert the Ethernet cable [A] into the Ethernet board on this option.
8. Insert the other end of the Ethernet cable to a PC for network setting.
9. Plug the power cord into the wall socket and turn ON the main power.
Do not unplug the USB connector while the machine is recognizing this option. It may
take between 30 seconds to 1 minute to finish recognizing it (the LEDs by the
connector light up when finished; see below). If unplugged, connect the cable again.
To Next Page
Loading...
