Electrical Components
D255/D256/M281/M282 4-146 SM
8. Plug in the power cord, and then turn ON the main power.
When the main power is turned ON, SC195-00 appears. Continue with the following
steps.
After changing the EEPROM, some SPs do not have the correct values.
Because of this, step 9 must be done.
9. Set the machine serial number SP5-811-001, area selection SP5-996-001, CPM set
SP5-882-001.
For information on how to configure the above SPs, contact the supervisor in your
branch office.
10. Turn the main power OFF/ON.
11. Execute SP5-801-002 "Memory Clear Engine".
12. Turn OFF the main power, and then turn it back ON.
13. From the SD card where you saved the NV-RAM data in step 5, download the NV-RAM
data with SP5-825-001.
14. Turn OFF the main power, and then remove the SD card from SD slot 2.
15. Turn ON the main power.
16. Check the SMC report (Factory SP Settings) from step 1, and set the user tool and SP
settings so they are the same as before.
To Next Page
Loading...
