Ricoh M281 Series - Page 381

Firmware Update
SM 5-11 D255/D256/M281/M282
System
Maintenance
Code Contents Solutions
32 The SD card used after
download suspension is
incorrect.
SD cards are different
between the one which was
inserted before power
interruption and the one which
was inserted after power
interruption.
 Insert the SD card containing the same
program as when the firmware update
was suspended, and then switch the
main power supply off and on to try
again.
 There is a possibility that the SD card
is damaged if the update cannot be
done after the correct SD card has
been inserted. In this case, try again
with a different SD card.
 Replace the controller board if the
above solutions do not solve the
problem.
Replace all relevant boards if the
update is done for the BiCU and FCU.
Replace the operation panel unit if the
update is done for the operation panel.
33 Card version error.
The wrong card version is
downloaded.
 Install the correct ROM update data for
each version in the SD card.
34 Destination error.
A card for the wrong
destination is inserted.
 Install the correct ROM update data for
each destination (JPN/ EXP/ OEM) in
the SD card.
35 Model error.
A card for the wrong model is
inserted.
 Install the correct ROM update data for
each model in the SD card.