Ricoh M281 Series - Page 510

Service Call 816-899
D255/D256/M281/M282 6-72 SM
No. Type Error Name/Error Condition/Major Cause/Solution
SC860-00 B HDD startup error at main power on (HDD error)
 The HDD is connected but the driver detected the following
errors.
 SS_NO.T_READY:/* (-2)HDD does not become READY*/
 SS_BAD_LABEL:/* (-4)Wrong partition type*/
 SS_READ_ERROR:/* (-5)Error occurred while reading or
checking the label*/
 SS_WRITE_ERROR:/* (-6)Error occurred while writing or
checking the label*/
 SS_FS_ERROR:/* (-7)Failed to repair the filesystem*/
 SS_MOUNT_ERROR:/* (-8)Failed to mount the filesystem*/
 SS_COMMAND_ERROR:/* (-9)Drive not responding to
command*/
 SS_KERNEL_ERROR:/* (-10)Internal kernel error*/
 SS_SIZE_ERROR:/* (-11)Drive size too small*/
 SS_NO._PARTITION:/* (-12)The specified partition does not
exist*/
 SS_NO._FILE:/* (-13)Device file does not exist*/
 Attempted to acquire HDD status through the driver but there
has been no response for 30 seconds or more.
 Unformatted HDD
 Label data corrupted
 HDD defective
Format the HDD (SP5-832: HDD formatting) through SP mode.