Ricoh M281 Series - Page 863

Error Codes
SM 29 D255/D256 FAX OPTION
D255/D256
FAX OPTION
Code Meaning Suggested Cause/Action
0-83
The line was disconnected
due to a timeout in the V.34
control channel restart
sequence.
setting.
If these errors happen at the receiving terminal:
 Try adjusting the RX cable equalizer
setting.
 Try increasing the TX level.
 Try using V.17 or a slower modem if the
same error is frequent when receiving from
multiple senders.
0-84
The line was disconnected
due to abnormal signaling in
V.34 phase 4 – control
channel start-up.
 The signal did not stop within 10 s.
 Turn OFF the main power, and then turn it
back ON.
 If the same error is frequent, replace the
FCU.
0-85
The line was disconnected
due to abnormal signaling in
V.34 control channel restart.
 The signal did not stop within 10 s.
 Turn OFF the main power, and then turn it
back ON.
 If the same error is frequent, replace the
FCU.
0-86
The line was disconnected
because the other terminal
requested a data rate using
MPh that was not available in
the currently selected symbol
rate.
 The other terminal was incompatible.
 Ask the other party to contact the
manufacturer.
0-87
The control channel started
after an unsuccessful primary
channel.
 The receiving terminal restarted the control
channel because data reception in the
primary channel was not successful.
 This does not result in an error
communication.
0-88
The line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
 Try using a lower data rate at the start.
 Try adjusting the cable equalizer setting.