Ricoh M281 Series - Page 890

IP-Fax Troubleshooting
D255/D256 FAX OPTION 56 SM
3 Gatekeeper/SIP server installed
correctly?
Contact the network administrator.
 The sender machine displays this
error code when the sender fax is
a Ricoh model.
4 Power to Gatekeeper/SIP server
turned ON?
Contact the network administrator.
 The sender machine displays this
error code when the sender fax is
a Ricoh model.
5 IP address/host name of
Gatekeeper/SIP server correct on the
sender's side?
Request the sender to check the IP
address/host name.
 The sender machine displays this
error code when the sender fax is
a Ricoh model.
6 DNS server registered when
Gatekeeper/SIP server host name
specified on sender's side?
Contact the network administrator.
 The sender machine displays this
error code when the sender fax is
a Ricoh model.
7 Enable H.323/Enable SIP SW set to
on?
Request the sender to check the settings.
User Parameter SW 34 Bit 0/SW 34 Bit 1
 Only if the remote sender fax is a
Ricoh fax.
8 Local fax IP address registered? Register the IP address.
9 Local fax Alias number registered? Register the Alias number.
10 Network bandwidth too narrow? Request the system administrator to
increase the bandwidth.
Lower the start modem reception baud rate
on the receiving side.
(IPFAX SW06)