Bit Switches - 1
D255/D256 FAX OPTION 78 SM
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
0: If the user has stored no acceptable sender
RTIs or CSIs, the user can select "ON" in the
authorized reception setting but the setting
becomes invalid ("OFF"). The machine will not
be able to receive any fax messages.
If the customer wishes to receive messages
from any sender that includes an RTI or CSI,
and to block messages from senders that do
not include an RTI or CSI, change this bit to
"0", then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
5-7 Not used Do not change the settings
* This setting can be used for the client machine which has no FCU.
System Switch 1F (SP No. 1-101-032)
No Function Comments
0 Not used Do not change the settings.
1 Report printout after an original
jam during SAF storage or if the
SAF memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory
overflows during scanning, a report will be
printed.
Change this bit to "1" if the customer does not
want to have a report in these cases.
Memory TX – Memory storage report
Parallel memory TX – Transmission result
report
2 Not used Do not change the settings.
3 Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately
after the machine receives it.
1: The machine prints the complete message
after the machine receives all the pages in the
memory.
4-6 Not used Do not change the factory settings.
To Next Page
Loading...
