Bit Switches - 3
D255/D256 FAX OPTION 98 SM
2 Treatment of pages received with
errors during G3 reception
0: Deleted from memory without
printing
1: Printed
0: Pages received with errors are not
printed.
3 Hang-up decision when a negative
code (RTN or PIN) is received
during G3 immediate transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN
or PIN is received.
1: The machine will send DCN and hang up
if it receives RTN or PIN.
This bit is ignored for memory
transmissions or if ECM is being used.
4-7 Not used Do not change these settings.
Communication Switch 03 (SP No. 1-104-004)
No Function Comments
0-7 Maximum number of page
retransmissions in a G3
memory transmission
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
Communication Switch 04 (SP No. 1-104-005)
No Function Comments
0 Remote mode switch (TEL mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to switch
TEL mode to FAX mode remotely.
1 Remote mode switch (FAX mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on
the remote mode switch after automatic
reception with FAX mode.
2 Remote mode switch (AUTO mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on
the remote mode switch after automatic
reception with AUTO mode.
3-7 Not used Do not change the settings.
To Next Page
Loading...
