Ricoh MP 2014AD - Page 158

Engine SP Mode
SM 5-14 D245/D246/D247
1907 [Paper Timing Adj.]
Adjusts the timing of paper feed. (A "+" setting broadens paper feed interval,
a “-” setting narrows paper feed interval.)
Parts Name -> ExitCL; Exit Clutch, D:ExCL; Exit Clutch in Duplex Mode,
D:ReCL; Relay Clutch in Duplex
1-907-001
ExitCL Stop Pos. *ENG [-30 to 30/ 0 / 1 mm / step]
1-907-002
ExitCL Start Pos. *ENG [-30 to 30/ 0 / 1 mm / step]
1-907-003
D:ExCL Stop Pos. *ENG [-30 to 30/ 0 / 1 mm / step]
1-907-004
D:ReCL Start Time *ENG [0 to 150/ 0 / 10 msec / step]
1-907-005
Duplex Feed Pos. *ENG [-30 to 30/ 0 / 1 mm / step]
1-907-006
Duplex Wait Pos. *ENG [-30 to 30/ 0 / 1 mm / step]
1911 [Bypass Envelope]
0 = Disabled / 1= Enabled
The program dedicated to envelope printing runs when you enable this
program (SP 1911 1) and you select "Thick Paper" as the paper type of the
by-pass tray (System Settings > Tray Paper Settings > Paper Type: Bypass
Tray).
1-911-001
Bypass Envelope *ENG [0 or 1 / 0 / 1 / step]
1950 [Fan]
Adjust the rotation time for fan motor after a job end.
1-950-001
Fan Cooling Time *ENG [0 to 900 / 60 / 1 sec / step]