Integration Server Authentication
For external authentication, the Integration Server authentication collectively authenticates users
accessing the server over the network, providing a server-independent, centralized user authentication
system that is safe and convenient.
To use the Integration Server authentication, software featuring Authentication Manager (e.g., Remote
Communication Gate S) is required. For details about supported software, contact your sales
representative.
Using Web Image Monitor, you can specify that the server reliability and site certificate are checked
every time you access the SSL server. For details about specifying SSL using Web Image Monitor, see
Web Image Monitor Help.
• During Integration Server Authentication, the data registered in the server, such as the user's e-mail
address, is automatically registered in the machine. If user information on the server is changed,
information registered in the machine may be overwritten when authentication is performed.
• The default administrator name for ScanRouter System and Remote Communication Gate S is
"Admin". This is different from the default administrator name for the machine, which is "admin".
Before beginning to configure the machine, make sure that administrator authentication is properly
configured under "Administrator Authentication Management".
1. Log in as the machine administrator from the control panel.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [ Next].
5. Press [User Authentication Management].
6. Select [Integration Svr. Auth.].
If you do not want to use user authentication management, select [Off].
7. Press [Change] for "Server Name".
Specify the name of the server for external authentication.
2. Configuring User Authentication
58
To Next Page
Loading...
Need help?
General
