Rigol DP832 Programming Guide

Chapter 5 Appendix RIGOL
DP800 Programming Guide 5-7
Cycles 1
End State Off
Object Volt
Templet
Sine
Delayer
Channel CH1
Delayer On/off
Off
Output Groups 1
Delayer Parameter
State: Off, On alternately
Cycles 1
End State Off
State Generation
0 1Pat
Time Generation
Generation Method
FixTime
On Delay 1s
Off Delay
1s
Time Base Value 1s
Step 1s
Stop Condition None
Recorder
Recorder Switch
Off
Record Period
1s
Destination
C:\REC 10:RIGOL.ROF
Analyzer
Channel Number
CH1
Analysis Object Volt
Display
Curve
Current Time
1s
Start Time
1s
End Time
2s
Monitor
Channel CH1
Monitor Switch
Off
Monitor Condition >Volt
Voltage
Half of the rated value
Current Half of the rated value
Power The product of voltage times current
Output Off
True
Warning
True
Beeper
True
Trigger
Direction In
Trigger Input
Data Line D0
Source under Control
CH1
Trigger Type RiseEdge
Output Response OutpClose
Sensitivity Low
Enable No
Trigger Output
Data Line D0

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD