Rigol DP832 Programming Guide

RIGOL Chapter 5 Appendix
5-8 DP800 Programming Guide
Control Source CH1
Trigger Condition OutpClose
Output Signal Level
Polarity
Pos
Enable No
Store
Browser Directory
File Type StateFile
Note*: these parameters don’t change when the instrument is restored to its factory settings (restarting the instrument
when “Default” is selected in Utility  System PowerOn or sending the *RST command can restore the
instrument to its factory settings).

Rigol DP832 Specifications

General

Number of Outputs	3
Output Voltage Range CH1/CH2	0-30V
Output Voltage Range CH3	0-5V
Output Current Range CH1/CH2	0-3A
Output Current Range CH3	0-3A
Total Power	195 W
Power per Channel CH1/CH2	90 W
Power per Channel CH3	15 W
Voltage Resolution	1 mV
Current Resolution	1 mA
Interfaces	USB, RS232
Display	3.5 inch TFT LCD