Rigol DS1074Z Plus Programming Guide

RIGOL Chapter 2 Command System
2-130 MSO1000Z/DS1000Z Programming Guide
[:SOURce[<n>]] Commands
The [:SOURce[<n>]] commands are used to set the parameters of the built-in signal source. <n> can be 1
or 2 which denotes the corresponding built-in signal source channel. When <n> or :SOURce[<n>] is
omitted, the operation will be applied to source 1 by default. These commands are only applicable to
models with source channels of MSO1000Z/DS1000Z series.
Command List:
 [:SOURce[<n>]]:OUTPut[<n>][:STATe]
 [:SOURce[<n>]]:OUTPut[<n>]:IMPedance
 [:SOURce[<n>]]:FREQuency[:FIXed]
 [:SOURce[<n>]]:PHASe[:ADJust]
 [:SOURce[<n>]]:PHASe:INITiate
 [:SOURce[<n>]]:FUNCtion[:SHAPe]
 [:SOURce[<n>]]:FUNCtion:RAMP:SYMMetry
 [:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
 [:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:OFFSet
 [:SOURce[<n>]]:PULSe:DCYCle
 [:SOURce[<n>]]:MOD[:STATe]
 [:SOURce[<n>]]:MOD:TYPe
 [:SOURce[<n>]]:MOD:AM[:DEPTh]
 [:SOURce[<n>]]:MOD:AM:INTernal:FREQuency
 [:SOURce[<n>]]:MOD:FM:INTernal:FREQuency
 [:SOURce[<n>]]:MOD:AM:INTernal:FUNCtion
 [:SOURce[<n>]]:MOD:FM:INTernal:FUNCtion
 [:SOURce[<n>]]:MOD:FM[:DEVIation]
 [:SOURce[<n>]]:APPLy?
 [:SOURce[<n>]]:APPLy:NOISe
 [:SOURce[<n>]]:APPLy:PULSe
 [:SOURce[<n>]]:APPLy:RAMP
 [:SOURce[<n>]]:APPLy:SINusoid
 [:SOURce[<n>]]:APPLy:SQUare
 [:SOURce[<n>]]:APPLy:USER

Rigol DS1074Z Plus Specifications

General

Type	Tabletop
Product type	-
Certification	UL 61010-1:2004; CAN/CSA-C22.2 NO. 61010-1-2004; EN 61010-1:2001; IEC 61010-1:2001
Bandwidth	70 MHz
Sampling rate	- MS/s
Channels quantity	4 channels
Minimum time base setting (per division)	5 ns
Power consumption (max)	50 W
Display diagonal	7 \
Non-operating altitude	3000 - 15000 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C

Weight and Dimensions

Depth	122.4 mm
Width	313.1 mm
Height	160.8 mm