10 ProSYS User Guide
Operating the System
The ProSYS can easily be operated locally or remotely depending on
the devices connected to the system.
You can issue commands to the system and in turn, the system will
communicate information to you via its display, indicators, voice
messages, SMS messages, Email messages and by the sounds it
makes.
The ProSYS can be operated in the following ways:
Ê Locally through its keypad(s). Using its keys, you can issue
commands to your system. In turn, the system can communicate
information to you via its display, indicators and sounds it makes.
Ê Local operation using wireless key fobs or panic pendants for
setting, unsetting send panic alarm or activate outputs.
Ê Local operation using Keyswitch for setting and unsetting the
system.
Ê If your system includes the Voice module, it can provide audible
information about system status, and enable any remote,
touch-tone (DTMF) telephone to act as a keypad for the system.
Upon event occurrence, such as alarm activation, the Voice
module informs you of a security situation by calling you and
playing a pre-recorded Event announcement, as described in the
Voice Module Programming and Operations Manual
Ê If your system is equipped with RISCO Group's GSM(AGM)/GPRS
module it can provide information about the system by SMS and
enable to operate the system using SMS commands for setting the
system, unsetting the system and more. For detailed information
refer to the manual provided with the GSM (AGM)/GPRS module.
Ê Local or remote operation using RISCO Group’s upload/Download
(UD) software. The UD enables the engineer to program the
system, and enables the user to operate the system and to view
system status.
The first task to be performed before operating the system is Defining
and Changing User Codes, as described on page 38.
To Next Page
Loading...
Need help?
General
