26 ProSYS User Guide
Quick Setting
Quick setting enables you to set the system with the press of a single
key.
NOTES:
Your engineer should define the Quick Setting feature.
For a system with multiple partitions, only the partition that the keypad is located
in will be set for Full Set or Part Set when the key or
key is
pressed.
To quick set using Full setting:
Ê Hold the tag close to the keypad's keys or press
. The
system (or partition) is fully set.
To quick set using Part Set setting:
Ê Hold the tag close to the keypad's keys or press
. The
system's (or partition's) external detectors are activated.
To quick set a group:
Ê Press the Function key corresponding to the group(s) you want to
set. The selected group(s) is set.
NOTE:
For a system with multiple partitions, the group inside the partition that the
keypad is located in will be set.
Setting in Blank Display Mode
To perform setting while the system is in Blank Display mode:
1)
Release the keypad by pressing [CODE] +
2)
Within 2 minutes time press:
For Full setting.
For Partial setting.
Keyswitch Setting
If your system is equipped with a special keyswitch, it can, with the
twist of a key, be toggled through Full Set and Unset modes.
To Next Page
Loading...
