ProSYS User Guide 23
THE JONESES
THE JONESES
AT PART SET
AT PART SET
THE JONESES
THE JONESES
AT PART SET
AT PART SET
When the system is set, the Set and Omit
LEDs will light together with a confirmation
message that will appear on the LCD for the
time defined by your engineer.
After that time the display will return to the
partition status display and the Power and
Ready LEDs light steadily.
The strobe will activate for 10 seconds
indicating a successful set of the system (if
defined).
Partition Setting
One of the advantages of ProSYS is its ability to divide any system into
a number of partitions. Each partition may be viewed as a separate
security system, each of which can be set and unset individually
regardless of the condition of the other.
Partitions can be set/unset one at a time or all at once, and can be set
in Part Set or Full Set.
Keypads and Partitions - Each keypad is assigned to different
partition(s). The Grand Master and the Manager (with access to all
partitions) can use any keypad to access any partition. Other users can
use only designated keypads.
NOTES:
Common Zones - Partitioned systems can share common zones. For example, a
shared front door to two family houses must be available to both families and is
therefore shared between them.
A common zone(s) is set only if all partitions sharing the zone(s) are set. The
common zone(s) is unset if any of the partitions, to which the zone(s) is assigned,
is unset.
If the system is defined to work in Area mode, the common zone will be set if any
partition sharing the zone is set. The common zone will be unset if all the
partitions sharing the zone are unset.
For more information about common zones refer to your engineer.
To Next Page
Loading...
