Risco ProSYS 128 - Quick Key Operation; LCD Status Display; LCD Blank Display

18 ProSYS User Guide
Quick Key Operation
The Quick Key Operation is a short effective way that helps you to
easily operate your system and quickly activate user functions, skipping
the user code. For example, to set the system, simply press the
key.
NOTE:
For quick key operation your engineer has to define quick key operation.
LCD Status Display
The LCD status display will vary depending on the number of partitions
in your system.
If your system is defined with only one partition, the LCD displays the
partition name, time and date.
If your system has 2 or 3 partitions, the LCD displays the system name,
date, time and the status of each partition. A status letter represents
the partition’s status, as follows:
SE: Partition is set NR: Partition Not Ready AL: Partition in Alarm
PS: Partition is set in Part set mode R: Partition Ready
LCD Blank Display
If defined by your engineer two minutes after the last keypad operation
the keypad will be disabled and the following display will appear on the
LCD:
Enter code:
_
Enter code:
_
To release the keypad and return to normal operation mode press:
[CODE] +
-or-
Present the Proximity Tag to Set/Unset the system.
NOTE:
During Blank Display mode the Ready LED indicates a fault in the system.