Risco ProSYS 128 - Resetting after an Alarm

ProSYS User Guide 29
Resetting after an Alarm
Your installation company can define that the reset of the system to a
Normal Operation mode will require the intervention of your ARC or
engineer. In this case, after an alarm condition, the display will show
"Call Engineer” message along with the contacting information as
defined by your engineer
Consult your engineer regarding the type of reset mode that your
system is set for, Remote Reset or Engineer Reset.
NOTE:
Before attempting to reset your system ensure that the system is unset.
Anti Code Reset
1)
Pressing on the
key while the "Call engineer" display is on
will enter you to the Anti Code section. Press
to enter the
Anti Code option.
2)
Call your ARC or engineer and quote the “RANDOM CODE”
displayed on your keypad. The ARC or engineer will give you a
return Anti-Code.
3)
Enter this Anti code followed by
and the system will reset.
Engineer Reset
Your Alarm Receiving Center (ARC) or engineer can reset your system
remotely or locally.
To enable local reset by your engineer you need to authorize him as
follows:
1)
Press
[2][0][3] while the "Call engineer" display is on.
2)
Enter Grand master, Master or Manager code followed by
. The following display appears:
Authorise eng.
Are you sure? N
Authorise eng.
Are you sure? N
3)
Use the
to select [Y] and press . A one hour time
window is opened for the engineer to program user functions
and be able to reset your system locally (Quick key [*][2][0]4]
from the main user menu).