Risco ProSYS 128 - Unsetting after an Alarm

28 ProSYS User Guide
Unsetting After an Alarm
If an alarm has occurred, it will be indicated by the keypad. Once the
cause of the alarm has been established the system must be reset.
To unset an alarm using a user code:
1)
If outside the premises, open an "entry" door. The
keypad(s) beeps, indicating that the Entry Delay period
has begun.
2)
Observe the keypad. If The Set LED is flashing, and the
display shows the activated partition, an alarm has
occurred. Pressing the
key will show the activated
partition and zone.
3)
Hold the tag close to the keypad's keys or enter your user
code and press
. If an alarm occurred, the SET LED
will flash. Scroll through the list of alarm zones. To To exit
the Alarm Memory mode before the timeout has expired,
press
.
4)
Proceed to “Resetting after an Alarm”
NOTES:
It is recommended to leave the premises. Only after police investigation
should you assume that the burglar is no longer on the premises and safely
re-enter.
In special cases (if programmed so during installation), setting the system
after an alarm requires a technician code. On the LCD, a “Call Engineer”
message will appear (see Resetting after an Alarm).
IMPORTANT:
If the alarm was caused by a tripped smoke detector(s), the keypad's Fire
LED will remain lit, providing an indication that the fire system must be reset
before it will be capable of detecting subsequent alarms. Furthermore, until it
is reset, you will be prevented from setting your system.
To reset a smoke detector, press [2] [2] [user code] .
Press to exit the User Functions mode.