ProSYS User Guide 19
Chapter 3: Setting and Unsetting the
System
Setting
Setting your system enables its intrusion detectors to trigger an alarm
when violated.
You can set your system by code setting, in which you need to use
your user code, or you can use quick setting (without using a code)
NOTE:
If during code setting you enter a wrong user code, the keypad produces
three short beeps. Press [ ] [ ] quickly and re-enter the sequence
correctly.
Before setting your system check the Ready LED. If it is lit or flashing,
the system is READY to be set. If NOT the system is NOT ready to be
set. In this case, secure or omit the violated zone(s), and then proceed
Remember, fire protection and the protection offered by the keypad's
emergency keys are always available (if authorised by your engineer)
NOTE:
If defined by your enginner, your system can be defined to for Force
setting. This definition sets the system regardless of open zones when
using a keyswitch or automatic setting.
Note that force setting the system results in leaving partition(s) unsecured.
Your ProSYS offers the following kinds of settings:
Ê Full, page 20
Ê Partial, page 22
Ê Partition, page 23
Ê Group, page 25
Ê Quick, page 26
Ê Blank Display, page 26
To Next Page
Loading...
