Risco ProSYS 128 - Deleting a Proximity Tag by the User Serial Number

ProSYS User Guide 57
NOTE:
A display of (****) indicates that a user has already been assigned to a
specific proximity tag.
6)
USER XX:
USER XX:
APPROACH
APPROACH
TAG TO UNIT
TAG TO UNIT
USER XX:
USER XX:
APPROACH
APPROACH
TAG TO UNIT
TAG TO UNIT
Within 10 seconds, approach the
proximity tag at a distance of 3 to 7 cm
from the keypad's keys. The keypad
automatically reads the proximity tag and
saves it into the system's memory.
Once the proximity tag has been
successfully recorded, a long confirmation
beep sounds, and a confirmation
message is displayed.
If the proximity tag is already stored in the
system's memory, the following message
is displayed: USER TAG ALREADY IN
MEMORY.
NOTES:
Once a proximity tag is recorded, it will be functional from all keypads.
The programmed proximity tag has the same permissions as are defined for
the specified user code.
If a user is defined as having the Cleaner security level, then the proximity
tag can operate only if a security code was previously defined for that user.
Deleting a Proximity Tag by the User Serial
Number
You can use this option to delete a proximity tag for which the user is
known.
To delete a proximity tag by user serial number:
1)
USER FUNCTIONS:
USER FUNCTIONS:
1) OMIT
1) OMIT
USER FUNCTIONS:
USER FUNCTIONS:
1) OMIT
1) OMIT
From the User Functions menu, select
[5] Access Code.
2)
INSERT CODE:
INSERT CODE:
INSERT CODE:
INSERT CODE:
Enter your user code and press
.
3)
ACCESS CODE:
1) UPDATE CODES
ACCESS CODE:
1) UPDATE CODES
Select [5] Prox Tag.