Risco ProSYS 128 - Chapter 10: Scheduling Weekly Programs; Automatic Setting;Unsetting

ProSYS User Guide 47
Chapter 10: Scheduling Weekly
Programs
[6] [Grand Master Code] [5]
Scheduling weekly programs enables you to automate some system
operations. This is performed by defining up to two time intervals per
day, during which the system automatically performs one of the
following functions:
Ê Automatic Setting/Unsetting, below
Ê Automatic PO Activation, page 49
Ê User Limitation, page 51
You can define automatic time intervals for every day in the
week, or individual days in the week. When performing this procedure,
use the data that you prepared in the table provided
in Appendix C: Scheduling Tables, page 71.
Automatic Setting/Unsetting
A setting program automatically sets and unsets the system at
predefined time intervals.
When defining the automatic setting/unsetting program, you need to
define the following parameters: Partition, Setting Mode, Time, and
Label.
To define an automatic setting/unsetting program:
1)
USER FUNCTIONS:
USER FUNCTIONS:
1) OMIT
1) OMIT
USER FUNCTIONS:
USER FUNCTIONS:
1) OMIT
1) OMIT
From the User Functions menu, select
[6] Clocks.
2)
INSERT CODE:
INSERT CODE:
INSERT CODE:
INSERT CODE:
Enter the Grand Master code and press
.
3)
SET CLOCKS:
SET CLOCKS:
1) SYSTEM TIME
1) SYSTEM TIME
SET CLOCKS:
SET CLOCKS:
1) SYSTEM TIME
1) SYSTEM TIME
Select [5] Scheduler.
4)
SCHEDULER:
SCHEDULER:
01)
01)
SCHEDULE 01
SCHEDULE 01
SCHEDULER:
SCHEDULER:
01)
01)
SCHEDULE 01
SCHEDULE 01
Select a program.
5)
SCHEDULE 01:
SCHEDULE 01:
01)
01)
SET/UNSET
SET/UNSET
SCHEDULE 01:
SCHEDULE 01:
01)
01)
SET/UNSET
SET/UNSET
Select [1] Set/Unset.