ProSYS User Guide 27
Wireless 4-Button Key Fob Setting
The system can be set using a button on a wireless 4-button key
fob. Your engineer programs this option. Refer to the instructions
supplied with your 4-button key fob for more information.
Unsetting
Unsetting your system deactivates its detectors. Unsetting can be
performed from any keypad, using a Keyswitch, a wireless button key
fob or automatically, if so defined. Remember, fire protection and the
protection offered by the keypad's emergency keys are always
available.
Your ProSYS offers the following kinds of unsetting:
Ê Unsetting the System, page 27
Ê Unsetting After an Alarm, page 28
Ê Resetting After an Alarm, page 29
Ê Partition Unsetting, page 29
Ê Duress Unsetting, page 31
Ê Disabling a Fire Alarm, page 32
Unsetting the System
Unsetting deactivates all detectors in the system.
To unset the system:
1)
If outside the premises, open an "entry" door. The
keypad(s) beeps, indicating that the Entry Delay Time
period has begun.
2)
Before the Entry Delay time period expires, hold the tag
close to the keypad's keys or enter your user code and press
. An « Unset » message display will appear on the
LCD.
NOTE:
If you make a mistake when entering your user code, the keypad will
produce three short beeps. If so, re-enter the sequence correctly.
To Next Page
Loading...
