Risco ProSYS 128 - Fire LED; Tamper LED

ProSYS User Guide 15
Fire LED
When lit, the Fire LED indicates that the system is experiencing a fire
alarm. When flashing, a problem has been detected on the fire circuit,
and must be serviced.
Condition Description
ON
A fire alarm or fire emergency is in progress or
has recently occurred.
OFF
All fire zones are operating normally.
FLASHING
A problem has been detected on the fire circuit
and it must be serviced.
Tamper LED
The Tamper LED indicates that a zone, a keypad, or an external
module has been tampered with and requires resetting. In some cases,
an Engineer code is required to restore the system to Normal
Operation mode.
Condition Description
ON
A zone, keypad, or an external module used by
the system has been physically disturbed or
tampered with. If unset without fixing the
problem, only the sound will be silenced.
NOTE:
The TAMPER LED shall NOT be on during tamper condition when the
system is SET.
If programmed by your engineer, resetting the TAMPER LED will require the
intervention an engineer.
OFF
There is no tamper alarm in the system.