20 ProSYS User Guide
Full Setting
Full setting prepares all of the system's intrusion detectors to trigger an
alarm, if violated, and is used when leaving the premises empty.
NOTE:
Before setting the panel all open zones must be closed.
The installation company can program your system to full set using one
of the following:
Timed Exit: After entering your code, the alarm system will set after a
predefined exit time delay. This will help you to leave via the exit route
without interfering with the setting process.
NOTE:
The exit delay time can be extended once, to the time defined by the exit
delay, by pressing the key during the exit delay time.
Final Exit: After entering your code, the system will go to Full Set 10
seconds after the final exit door is closed.
Exit Terminator: After entering your code, the system will go to Full
Set 10 seconds after you press the Exit Terminator button (a push
button normally mounted outside the premises).
To Full Set:
1)
Check the Ready LED on your keypad. If it is constantly lit, the
system is READY to be set.
If the Ready LED is not lit the system is not ready to be set. In
this case, secure or omit the violated zone(s), as described on
page 22, and then proceed.
If the Ready LED is flashing, there are faults in the system
that need to be confirmed before continuing with the Full SET
process. (Ask your engineer if defined.)
2)
THE JONESES
THE JONESES
05:42 DEC 16 TUE
05:42 DEC 16 TUE
THE JONESES
THE JONESES
05:42 DEC 16 TUE
05:42 DEC 16 TUE
Hold the tag close to the keypad's keys or
Enter your user code and press
.
NOTE:
If required, all faults in the system should be confirmed to enable the setting
operation. Scroll down the list of fault/s using the key. At the end of
the list the following question will appear: « OVERIDE FLT? » Use the
key to toggle the option to Y and press .
To Next Page
Loading...
